Puyallup, Pierce County
Chimney relining in Puyallup starts at $1,900 for a full-length stainless steel liner, and the final figure depends on how tall the flue is, its shape and the appliance it has to serve. A liner is the tube that carries smoke and gases safely out of the house; when the original clay tiles have cracked, or a new stove needs a flue of the right size, relining is the fix that makes the chimney usable again.
Typical investment
From $1,900
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Puyallup home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Puyallup homes.
Level 1 or Level 2 as needed; Level 2 includes a camera run through the entire flue
Learn more
Top-to-bottom brushing of flue and firebox under drop cloths, with a HEPA vacuum pulling the dust
Learn more
Loose or damaged brick, open joints and firebox panels repaired
Learn more
A stainless cap sized to your actual flue dimensions
Learn more
Burner, pilot assembly and valve cleaned and adjusted
Learn more
Crown patched, or recast entirely if it can't be saved
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
In Puyallup, relining requests usually come from one of two directions. Owners of older masonry chimneys near the original town, some from before 1960, discover cracked or missing clay tiles during an inspection. Other owners are swapping an old wood stove for a certified one, or adding an insert to a fireplace, and the new unit needs a properly sized liner connected to it.
About 6,700 occupied homes in Pierce County, roughly 1.9%, use wood as their main heat, per Census Bureau estimates for 2020 to 2024; in Puyallup the share is about 0.8%.
For those homes, the stove runs for months at a time, and the flue behind it works hard. A cracked clay tile lets heat and gases reach the brick and the framing around it. When wood is your main heat, relining is not an upgrade; it is what lets you keep using the stove safely. And if the stove is truly your only adequate heat, the clean air agency expects you to hold an approved exemption before burning through a ban, so a sound flue and that paperwork belong on the same fall checklist.
The Tacoma-Pierce County wood stove rule has, since October 2015, made it illegal to operate or reinstall an uncertified stove or insert inside the county's Smoke Reduction Zone. An uncertified unit has to be removed and recycled, or made inoperable, and the rule leaves EPA-certified stoves alone.
The agency's recycling program pays homeowners who take a working old stove or insert to an approved recycler. Many Puyallup owners use that moment to put in a certified unit, and that is exactly when the liner should be sized for the new stove, not left from the old one.
Every chimney relining we do in Puyallup includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowThe appliance change is the part people underestimate. Under Washington's residential code a masonry chimney must be lined, and the City of Puyallup requires a mechanical permit to install, replace or relocate a wood or gas stove. That means a new stove dropped into an old, oversized flue without a liner is both a safety problem and a permit problem. We size the liner to the appliance's outlet and manufacturer instructions, not to whatever fits down the chimney.
The WRCC record for the Puyallup valley station shows about 69 nights a year at or below freezing, and an average of 6.3 inches of snow a year between 1931 and 1995.
Clay flue tiles are brittle. Moisture that condenses inside a cold flue, or rain that enters through a damaged crown, freezes in the joints and slowly pushes tiles out of line. A stainless liner is not affected in the same way, which is one reason it is the usual replacement in valley chimneys.
A camera pass shows the flue's condition, and we measure its height and inner size against the appliance you plan to run.
The flue is swept, loose debris removed and any tile pieces that would block the liner cleared.
From the roof, the stainless liner is lowered in, joined to the appliance at the bottom and fixed with a top plate and cap.
We check draft with the appliance running where possible and send you the camera footage and photos.
What this work is quoted at for Puyallup homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Puyallup | What that covers |
|---|---|---|
| Chimney Relining | From $1,900 | Full-length stainless liner, sized to the appliance |
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Repair | From $375 | Masonry repair — brick and mortar, scoped after diagnosis |
| Chimney Cap Installation | $265–$750 | Stainless cap fitted; multi-flue and custom at the top |
Ranges are what these jobs are quoted at in Puyallup. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Puyallup is a valley city platted by Ezra Meeker in 1877, at the heart of what was a leading hop-growing region, on the Puyallup River valley, with homes with a median build year of 1987, about 39% of them built before 1980.
PuyallupPierce County, WA · 47.185, -122.293
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
From $1,900 for a full-length stainless liner. Tall chimneys, oval or offset flues, insulation wraps and multi-flue stacks raise the price, and the written quote shows each part.
If the job installs, replaces or relocates a wood or gas stove, the city requires a mechanical permit. We tell you at the quote stage whether your job needs one.
Yes, with a liner rated for that appliance. Gas and wood liners are not interchangeable, and we match the liner to what the flue serves.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
