Puyallup, Pierce County
Chimney cap installation in Puyallup costs $265 to $750. A single-flue stainless cap on an easy roof lands near the low end; a wide multi-flue cap, a custom size or a steep roof moves it toward the top. The cap does three jobs at once: it keeps rain out of the flue, it stops birds and raccoons from moving in, and its mesh catches sparks before they reach the roof.
Typical investment
$265–$750
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Puyallup home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Puyallup homes.
Level 1 or Level 2 as needed; Level 2 includes a camera run through the entire flue
Learn more
Top-to-bottom brushing of flue and firebox under drop cloths, with a HEPA vacuum pulling the dust
Learn more
Loose or damaged brick, open joints and firebox panels repaired
Learn more
A full-length stainless-steel or cast liner, firebox to chimney top
Learn more
Burner, pilot assembly and valve cleaned and adjusted
Learn more
Crown patched, or recast entirely if it can't be saved
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
Many older Puyallup chimneys were built with an open flue tile and nothing over it, and on some newer homes the original cap or chase top has rusted through. Both show up in the same way: water in the firebox after a storm, rust streaks on the chimney, or nesting sounds in spring. We fit caps on brick chimneys with a single flue, on stacks carrying two or three flues, and on the metal chimneys of factory-built fireplaces.
Wood heats about 0.8% of Puyallup homes as their main fuel, according to the Census Bureau's latest five-year estimates, compared with about 2.8% statewide.
A stove running most days of the winter sends a steady stream of hot gases and the occasional ember up the flue. In a home like that the spark mesh on the cap works constantly, and it needs to be in good shape. The clean air agency also reminds owners who depend on wood that burning during a ban requires an approved exemption, and that visible smoke is still prohibited, so a clean, free-drafting cap helps on both counts.
Every chimney cap installation we do in Puyallup includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowThe Washington State Fire Marshal's heating safety guidance advises a chimney cap along with annual inspection and cleaning. The state residential code also sets rules where a spark arrestor is fitted: the mesh must stop spheres larger than half an inch, pass spheres of three-eighths of an inch, and be removable for cleaning. We install caps whose screens meet those limits.
The Puyallup valley station averaged 39.84 inches of precipitation a year between 1931 and 1995, plus a little over six inches of snow. Without a cap, a share of that lands directly inside the chimney.
Water that enters the flue soaks the smoke chamber, rusts the damper and, on the valley's roughly 69 freezing nights a year, can freeze in cracked tile joints. A cap is the least expensive way to stop most of it.
We measure each flue opening and look at the crown to choose between a single-flue cap and one that covers the whole top.
Any nest material, leaves or debris at the top of the flue are removed before the cap goes on.
The cap is secured so it stays on through winter wind, and the mesh is checked for gaps.
Photos from the roof confirm the finished fit and note anything we saw on the crown.
What this work is quoted at for Puyallup homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Puyallup | What that covers |
|---|---|---|
| Chimney Cap Installation | $265–$750 | Stainless cap fitted; multi-flue and custom at the top |
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Relining | From $1,900 | Full-length stainless liner, sized to the appliance |
| Chimney Repair | From $375 | Masonry repair — brick and mortar, scoped after diagnosis |
Ranges are what these jobs are quoted at in Puyallup. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Puyallup is a valley city platted by Ezra Meeker in 1877, at the heart of what was a leading hop-growing region, on the Puyallup River valley, with homes with a median build year of 1987, about 39% of them built before 1980.
PuyallupPierce County, WA · 47.185, -122.293
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
$265 to $750 installed. The size of the flue, the number of flues under one cap and roof access set the price.
A correctly sized cap does not. Draft problems come from an undersized cap or a mesh clogged with soot, which is why the screen must be easy to clean.
Yes. A multi-flue cap covers the whole top of the stack, which also shields the crown from rain.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
