Puyallup, Pierce County
Gas fireplace service in Puyallup costs $189 to $475. A routine tune-up on an accessible unit lands at the bottom of that range; a unit that needs parts, a deep clean of a sooted burner area, or work on a hard-to-reach vent moves toward the top. The goal is simple: a fireplace that lights on the first try, burns with a steady flame and vents its exhaust outside where it belongs.
Typical investment
$189–$475
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Puyallup home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Puyallup homes.
Level 1 or Level 2 as needed; Level 2 includes a camera run through the entire flue
Learn more
Top-to-bottom brushing of flue and firebox under drop cloths, with a HEPA vacuum pulling the dust
Learn more
Loose or damaged brick, open joints and firebox panels repaired
Learn more
A full-length stainless-steel or cast liner, firebox to chimney top
Learn more
A stainless cap sized to your actual flue dimensions
Learn more
Crown patched, or recast entirely if it can't be saved
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
Gas fireplaces are common in the homes built on the hill above the old town and in the subdivisions of the past few decades, where the median Puyallup house dates from 1987. Older homes have them too, often as gas logs set into a former wood-burning fireplace. Each type is serviced differently: a sealed direct-vent unit is about the glass, gasket and vent termination, while gas logs in a masonry fireplace depend on the damper and the flue above them.
Only about 0.8% of Puyallup homes use wood as their main heating fuel today, per the Census Bureau's 2020 to 2024 estimates, below the county's roughly 1.9%.
Some of the gas fireplaces we service replaced a wood stove. The regional clean air agency offers a cash payment when a Pierce County owner hauls an outdated but still functioning wood heater to one of its approved recycling yards; getting the unit out and delivered is the owner's job. If you are weighing that switch, a gas unit or gas logs on a sound flue is one of the options worth pricing.
Burn bans in Pierce County are called by Puget Sound Clean Air Agency under the state curtailment rule, WAC 173-433-150. Stage 1 stops wood fireplaces along with uncertified stoves and inserts; Stage 2 halts all wood-burning fireplaces, stoves and inserts plus pellet stoves, certified or not.
The devices named in both stages burn wood or pellets. A gas fireplace is not on that list, which is one reason some Puyallup households keep one working as a backup for ban days. Current ban status appears on the agency's website and on its line, 800-595-4341.
Every gas fireplace service we do in Puyallup includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowPaperwork matters for gas work in Puyallup. The city requires a mechanical permit to install, replace, alter or relocate gas logs, a gas stove or gas piping. Routine service does not change the appliance, but if a tune-up turns up a part of the gas line or the appliance that needs replacing, we tell you before anything is done whether a permit applies.
Gas is turned off at the valve and the unit is allowed to cool before the glass comes off.
Burner, ports, pilot and logs are cleaned, and the glass and gasket are checked for a proper seal.
We inspect the vent path and the outside termination for blockage, damage or nesting.
The unit runs through a full cycle while we check the flame, controls and draft.
What this work is quoted at for Puyallup homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Puyallup | What that covers |
|---|---|---|
| Gas Fireplace Service | $189–$475 | Annual service and tune-up; repairs quoted after diagnosis |
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Relining | From $1,900 | Full-length stainless liner, sized to the appliance |
| Chimney Repair | From $375 | Masonry repair — brick and mortar, scoped after diagnosis |
Ranges are what these jobs are quoted at in Puyallup. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Puyallup is a valley city platted by Ezra Meeker in 1877, at the heart of what was a leading hop-growing region, on the Puyallup River valley, with homes with a median build year of 1987, about 39% of them built before 1980.
PuyallupPierce County, WA · 47.185, -122.293
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
$189 to $475. A standard tune-up is at the low end; parts or extra work on the vent raise it, and we quote before replacing anything.
Once a year, ideally in late summer or fall before regular use. Pilot and burner problems tend to show up on the first cold evening.
Not a brush sweep, but the vent still needs checking. Gas logs in a masonry fireplace also rely on the flue above them being clear.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
