Lakewood, Pierce County
Servicing a gas fireplace in Lakewood is $189 to $475. If yours fires up every time and only needs its yearly cleaning, expect the bottom of that bracket. The upper part of the range covers a unit with a weak or failing pilot, heavy soot on the glass and logs, or a vent that needs work to reach. Repairs that need parts are quoted separately once we know what has failed.
Typical investment
$189–$475
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Lakewood home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Lakewood homes.
Level 1 or Level 2 as needed; Level 2 includes a camera run through the entire flue
Learn more
Top-to-bottom brushing of flue and firebox under drop cloths, with a HEPA vacuum pulling the dust
Learn more
Loose or damaged brick, open joints and firebox panels repaired
Learn more
A full-length stainless-steel or cast liner, firebox to chimney top
Learn more
A stainless cap sized to your actual flue dimensions
Learn more
Crown patched, or recast entirely if it can't be saved
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
Gas fireplaces in Lakewood come in two main forms. One is a gas insert or log set placed in an original 1960s or 1970s masonry fireplace, usually to replace a wood fire that was drafty or smoky. The other is a factory-built gas fireplace framed into a wall, venting straight out the side of the house. Each has its own checks: the first depends on the old chimney doing its job, the second on a sealed vent kit staying intact.
About 58.9% of Lakewood homes predate 1980 and the median was built in 1975, per Census estimates, so many of the gas units we service sit in fireplaces designed for wood. Switching from wood to gas changes what the flue carries: cooler, moister exhaust instead of hot smoke, and a clay flue that was fine for a wood fire can let that moisture condense and eat at its mortar.
Swapping one appliance for a different type is, for NFPA 211 and CSIA, grounds for a Level II inspection, and that level comes with a camera pass through the flue. On a gas insert in an older Lakewood fireplace, we check that it vents through a liner of its own, rather than straight into the original masonry flue.
Every gas fireplace service we do in Lakewood includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowMost calls come in October, when the unit that sat idle since spring will not stay lit. Spiders and dust in the pilot assembly, a dirty thermocouple or thermopile, and soot on the logs from a misadjusted flame account for most of them. On inserts vented into an old masonry flue, we also look for rainwater getting down the chimney during Lakewood's long wet season, since corrosion at the bottom of a vent can let exhaust into the room.
A gas insert does not stop the brick chimney around it from cracking. The Nisqually quake of 2001, a magnitude 6.8 roughly 52 km beneath Anderson Island, damaged chimneys in about one of every three homes FEMA looked at, the USGS report says, and a chimney that took a hit then may well be venting a gas unit today.
If the flue your gas insert vents through has a crack, exhaust can escape into the chimney chase or the house. After a seismic event, NFPA 211 calls for a Level II look at the chimney, and for a gas unit that means checking the vent's full run as well as the burner.
We run the unit if it will light and watch the flame, then shut off the gas and let the fireplace cool.
The glass comes off, and the pilot, burner, logs and firebox are cleaned. Dust and insect nests are removed from the pilot and ports.
We follow the vent to its termination outside or up the chimney, looking for blockage, corrosion or loose joints.
The unit is reassembled and fired, the flame adjusted, and you get photos and a note of anything that needs parts.
What this work is quoted at for Lakewood homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Lakewood | What that covers |
|---|---|---|
| Gas Fireplace Service | $189–$475 | Annual service and tune-up; repairs quoted after diagnosis |
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Relining | From $1,900 | Full-length stainless liner, sized to the appliance |
| Chimney Repair | From $375 | Masonry repair — brick and mortar, scoped after diagnosis |
Ranges are what these jobs are quoted at in Lakewood. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Puget Sound Clean Air Agency's Stage 2 ban, the stricter of the two, covers every wood fireplace, wood stove and wood insert, certified or not, and pellet stoves as well. Stage 1 covers wood-burning fireplaces and uncertified stoves and inserts. WAC 173-433-150, the statewide curtailment rule, follows that same structure.
Gas appliances are not among the devices those stages name. For Lakewood households that like a fire on the still, cold evenings when bans tend to be called, a well-serviced gas unit is the one that stays usable.
Lakewood is a city incorporated in 1996 around a string of lakes where Tacoma families first built lodges in the late 1800s, on American Lake, with homes with a median build year of 1975, about 59% of them built before 1980.
LakewoodPierce County, WA · 47.172, -122.519
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
$189 to $475 for the service. Parts and repairs, such as a new thermocouple or igniter, are quoted before anything is replaced.
Yes. Under NFPA 211, every chimney, fireplace and vent gets looked at once a year or more, gas units included.
The published ban stages name wood fireplaces, wood stoves and inserts, and pellet stoves. A gas unit is not on that list.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
