Milton, Pierce County
Milton chimney sweeping is priced between $189 and $449. A single-story ranch with a short flue and one winter of soot sits at the low end; a two-story stack on a steep roof with years of buildup sits near the top. Either way the brush travels the full height, the smoke shelf gets scraped, and your living room gets covered before any of that starts.
Typical investment
$189–$449
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Milton home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Milton homes.
Level 1 or Level 2 as needed; Level 2 includes a camera run through the entire flue
Learn more
Loose or damaged brick, open joints and firebox panels repaired
Learn more
A full-length stainless-steel or cast liner, firebox to chimney top
Learn more
A stainless cap sized to your actual flue dimensions
Learn more
Burner, pilot assembly and valve cleaned and adjusted
Learn more
Crown patched, or recast entirely if it can't be saved
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
Milton's housing was built across a long stretch of decades, and it shows in what we pull the cap off. One street can give us an unlined brick flue from the town's older years, a clay-tiled one from mid-century, and a steel pipe inside a framed chase from the 1990s. Soot sticks to all three. Knowing which one we are brushing decides the head size, how hard we push, and whether a liner needs gentler treatment.
Wood is the primary heat in roughly 6,700 occupied homes across Pierce County, or about 1.9 percent, in Census survey data covering 2020 through 2024. In those homes the stove may be going from October into spring.
Some of them can keep burning during a ban, but only with an exemption approved in advance by the Puget Sound Clean Air Agency, and the agency does not accept a pricey furnace or a temporarily broken one as a reason. A flue that works that hard should be swept according to what comes out of it, not by the calendar.
Only firewood that is dry and seasoned, or manufactured logs, is legal to burn under Clean Air Agency rules. The visible plume is limited too: it may not hit 20 percent opacity for a six-minute stretch in any hour.
On a Stage 1 day, open wood fireplaces and uncertified stoves and inserts are off limits. A clean flue that drafts well is the simplest way to keep the smoke light on the days a fire is allowed.
Every chimney sweep we do in Milton includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowThe call we get most in Milton is from someone who lit the first fire of fall and got a living room full of smoke, because leaves and a squirrel's stash were sitting on the damper. The second most common is a stove that burned a whole winter on firewood left out in the rain, which coats the flue with a sticky layer that a brush alone barely moves.
WeatherSpark's Milton data has the wet half of the year running from about October 9 to May 2, while a typical July brings only around 0.7 inches of rain. That leaves late summer as the easy season for roof work.
Washington's State Fire Marshal advises a yearly professional chimney check and cleaning, along with a cap on top. An August or September appointment gets it done on a dry roof, before the first real fire.
Cloths cover the floor between your entry and the fireplace, and a HEPA vacuum is taped over the opening to hold the dust.
A quick check from the roof and the firebox tells us if it is brick, tile, stainless or a factory-built pipe.
Rods and a correctly sized brush clear the whole run, then the smoke shelf and damper get hand tools.
We go over the photos with you and flag anything that should be looked at before next winter.
What this work is quoted at for Milton homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Milton | What that covers |
|---|---|---|
| Chimney Sweep | $189–$449 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Relining | From $1,900 | Full-length stainless liner, sized to the appliance |
| Chimney Repair | From $375 | Masonry repair — brick and mortar, scoped after diagnosis |
| Chimney Cap Installation | $265–$750 | Stainless cap fitted; multi-flue and custom at the top |
Ranges are what these jobs are quoted at in Milton. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Milton is a hillside city incorporated in 1907 around a sawmill overlooking the Puyallup Valley, with homes with a median build year of 1988, about 35% of them built before 1980.
MiltonPierce County, WA · 47.248, -122.313
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
$189 to $449. Expect about $189 for a low roof with little soot; a tall, steep or heavily coated flue moves it toward $449.
Maybe not every year, since buildup follows use. But leaves and nests arrive whether you burn or not, so a yearly look is still worth it.
No, gas units get a gas fireplace service rather than a sweep. We will say which your fireplace needs once we see it.
You get photos, an explanation and a written quote. No extra work is done unless you say yes.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
